EZ5 MIB Catalog

CISCO-L2L3-INTERFACE-CONFIG-MIB

2000-05-10

Interface switchport mode configuration management MIB. This MIB is used to monitor and control configuration of interface switchport and routed mode.

Download CISCO-L2L3-INTERFACE-CONFIG-MIB.txt Open CISCO-L2L3-INTERFACE-CONFIG-MIB.txt in a new tab

TABLES (1)

Tables (1)

NameOID
cL2L3IfTable1.3.6.1.4.1.9.9.151.1.1.1

END OF TOC

Table details

cL2L3IfTable

1.3.6.1.4.1.9.9.151.1.1.1

Index: ifIndex

The table shows the administratively requested and actual operating configuration for switchport interfaces.

from IF-MIB

ifIndex

InterfaceIndexA unique value, greater than zero, for each interface or interface sub-layer in the managed system. It is recommended that values are assigned contiguously starting from 1. The value for each interface sub-layer must remain constant at least from one re-initialization of the entity's network management system to the next re-initialization. (1..2147483647) · Integer32 · hint d

A unique value, greater than zero, for each interface. It is recommended that values are assigned contiguously starting from 1. The value for each interface sub-layer must remain constant at least from one re-initialization of the entity's network management system to the next re- initialization.

cL2L3IfModeAdmin

1.3.6.1.4.1.9.9.151.1.1.1.1.1

CL2L3InterfaceMode1 = routed2 = switchportThe operational mode of the interface. For administrative and operational states, valid values are: routed(1), switchport(2). routed(1): Routed mode interfaces direct traffic using layer 3 protocols. switchport(2): Switchport-mode interfaces direct traffic using layer 2 protocols. A switchport-mode interface can be in access mode, or trunk mode, or multi-mode. Switchport interface operating mode can be configured manually, or negotiated by Dynamic Trunking Protocol (DTP) or Dynamic Inter-Switch Link (DISL). Access-mode interfaces carry one VLAN's traffic. Access-mode interface parameters are configured in CISCO-VLAN-MEMBERSHIP-MIB. Trunk-mode interfaces carry one or more VLANs. VLAN-related trunk-mode interface parameters are configured in CISCO-VTP-MIB. Multi-mode interfaces carry one VLAN to each alias of a single connected end-station. VLAN-related multi-mode interface parameters are configured in CISCO-VTP-MIB. · Integer32

The administratively desired interface mode.

cL2L3IfModeOper

1.3.6.1.4.1.9.9.151.1.1.1.1.2

CL2L3InterfaceMode1 = routed2 = switchportThe operational mode of the interface. For administrative and operational states, valid values are: routed(1), switchport(2). routed(1): Routed mode interfaces direct traffic using layer 3 protocols. switchport(2): Switchport-mode interfaces direct traffic using layer 2 protocols. A switchport-mode interface can be in access mode, or trunk mode, or multi-mode. Switchport interface operating mode can be configured manually, or negotiated by Dynamic Trunking Protocol (DTP) or Dynamic Inter-Switch Link (DISL). Access-mode interfaces carry one VLAN's traffic. Access-mode interface parameters are configured in CISCO-VLAN-MEMBERSHIP-MIB. Trunk-mode interfaces carry one or more VLANs. VLAN-related trunk-mode interface parameters are configured in CISCO-VTP-MIB. Multi-mode interfaces carry one VLAN to each alias of a single connected end-station. VLAN-related multi-mode interface parameters are configured in CISCO-VTP-MIB. · Integer32

The operational interface mode.

↑ To TOC